Page 10 of 66 0455-0323 Rev A
SIP Configurations
At least one SIP line should be configured properly to enable the telephony service. The line
configuration is like a virtualized SIM card. Just like a SIM card on a mobile phone, it stores the
service provider and the account information used for registration and authentication. When the
device is applied with the configuration, it will register the device to the service provider with the
server’s address and user’s authentication as stored in the configurations.
The SIP line configuration should be set via the WEB configuration page by entering the correct
information such as phone number, authentication name/password, SIP server address, server port,
etc. which are provided by the SIP server administrator.
•
WEB interface ： After login into the phone page, enter [Line] >> [SIP] and select SIP1/SIP2 for
configuration, click apply to complete registration after configuration, as shown below:
Door opening operation
Unlock the door in the following five ways:
1.
Open the door by swiping the RFID card, which supports IC card and ID card.
2.
The access control helps to call owner, and the owner enters the remote opening password to
open the door.
3.
The other device helps to call the door phone, enters the corresponding remote authentication
code, and opens the door after timeout or the password check length is reached (the
authentication code shall be configured in the access list).
4.
The door can be opened through the indoor door button when the door phone is in any state.
5.
Timed door opening: automatically opens the door in a predetermined time period by setting a
timed task.
To Next Page
Loading...
Need help?
General
