Page 35 of 66 0455-0323 Rev A
Line >> Dial Plan
Parameters Description
Press # to invoke dialing The user dials the other party's number and then adds the # to
dial out;
Dial Fixed Length The number entered by the user is automatically dialed out when
it reaches a fixed length
The device dials automatically after timeout
Dial Plan Add:
There are two types of matching: Full Matching or Prefix Matching. In Full
matching, the entire phone number is entered and then mapped per the Dial
Peer rules.
In prefix matching, only part of the number is entered followed by T. The
mapping will then take place whenever these digits are dialed. Prefix mode
supports a maximum of 30 digits.
Note: Two different special characters are used.
•
x -- Matches any single digit that is dialed.
•
[ ] -- Specifies a range of numbers to be matched. It may be a range, a list of ranges
separated by commas, or a list of digits.
Set Destination address. This is for IP direct.
Set the Signal port, and the default is 5060 for SIP.
To Next Page
Loading...
Need help?
General
