Page 18 of 66 0455-0323 Rev A
Send the multicast configuration information by Sip Notify signaling, and
the device will configure the information to the system for multicast
listening or cancel the multicast listening in the system after receiving the
information
Delete Time
When a multicast call does not end normally, but for some reason the
device can no longer receive a multicast RTP packet, this configuration
cancels the listening after a specified time
Defines the priority in the current call, with 1 being the highest priority
and 10 the lowest.
Compared with multicast and SIP priority, high priority is pluggable and
low priority is rejected
Regardless of which of the two multicast groups is called in first, the
device will receive the higher priority multicast first.
When enabled, play the prompt sound when receiving multicast
Listened multicast server name
Listened multicast server’s multicast IP address and port.
Multicast
：
•
Go to web page of [Function Key] >> [Function Key], select the type to multicast, set the
multicast address, and select the codec.
•
Click Apply.
•
Set up the name, host and port of the receiving multicast on the web page of [Intercom Settings]
>> [MCAST].
•
Press the DSSKey of Multicast Key which you set.
•
Receive end will receive multicast call and play multicast automatically.
MCAST Dynamic
：
Description: send multicast configuration information through SIP notify signaling. After receiving the
message, the device configures it to the system for multicast monitoring or cancels multicast
monitoring in the system.
Hotspot
SIP hotspot is a simple utility. Its configuration is simple, which can realize the function of group
vibration and expand the quantity of sip account. Take one device A as the SIP hotspot and the other
devices (B, C) as the SIP hotspot client. When someone calls device A, devices A, B, and C will ring,
and if any of them answer, the other devices will stop ringing and not be able to answer at the same
time. When A B or C device is called out, it is called out with A SIP number registered with device A.
Enable Hotspot Enable or disable hotspot
Mode This device can only be used as a client
The monitoring type can be broadcast or multicast. If you want to restrict
broadcast packets in the network, you can choose multicast. The type of
monitoring on the server side and the client side must be the same, for
example, when the device on the client side is selected for multicast, the
device on the SIP hotspot server side must also be set for multicast
To Next Page
Loading...
Need help?
General
