ESI A64v User Manual

Page 42 of 66 0455-0323 Rev A
Intercom settings >> Media
Parameters
Description
Codecs Settings
Select the enabled and disabled voice codecs
codec: G.711A/U,G.722,G.729,ILBC,opus
Media Setting
Default Ring Type
Set the default ring type. If the caller ID of an incoming call was not
configured with specific ring type, the default ring will be used.
Speakerphone Volume
Set the speakerphone volume, the value must be 1~9
Speakerphone Ring Volume
Set the ring volume in the speakerphone, the value must be 1~9
Speakerphone Ring Volume
Set the ring volume in the speakerphone, the value must be 1~9
DTMF Payload Type
Enter the DTMF payload type, the value must be 96~127.
Opus payload type
Enter the opus payload type, the value must be 96~127.
OPUS Sample Rate
Set the opus sample rate including OPUS-NB（ 8KHz ),
OPUS- WB（16KHz）
ILBC Payload Type
Set the ILBC Payload Type
ILBC Payload Length
Set the ILBC Payload Length
Enable VAD
Enable Voice Activity Detection. When enabled, the device will
suppress the audio transmission with artificial comfort noise signal to
save the bandwidth.
H.264Payload Type
Set the H264 Payload Type. The value must be 96~127.
RTP Control Protocol(RTCP) Settings
CNAME user
Set CNAME user
CNAME host
Set CNAME host
RTP Settings
RTP keep alive
Hold the call and send the packet after 30s
Alert Info Ring Settings
Value
Set the value to specify the ring type.
Ring Type
Type1-Type9

ESI A64v Specifications

General

Brand	ESI
Model	A64v
Category	IP Access Controllers
Language	English