Page 60 of 66 0455-0323 Rev A
EGS Setting >> Features
Monostable: there is only one fixed action status for door unlocking.
Bistable: there are two actions and statuses, door unlocking and door
locking. Each action might be triggered and changed to the other status.
After changed, the status would be kept.
Initial Value is Monostable
Door unlocking time for Monostable mode only. If the time is up, the door
would be locked automatically. Initial Value is 5 seconds.
Monostable: there is only one fixed action status for door unlocking.
Bistable: there are two actions and statuses, door unlocking and door
locking. Each action might be triggered and changed to the other status.
After changed, the status would be kept.
Initial Value is Monostable
Door unlocking time for Monostable mode only. If the time is up, the door
would be locked automatically. Initial Value is 5 seconds.
Independent: Open the door independently with Relay1 Synchronous:
open the door at the same time as Relay1 Asynchronous: Relay1 opens
after a period of time Relay2 opens
The user can set the asynchronous door opening delay time of
Relay1 and Relay2, the default is 1 second
Supported access control card format
Supported Wiegand access card format
Optional input port or output port
password
After enabling, the correct password will be included in the consecutively
entered numbers to open the door
Enable or disable card reader for RFID cards.
Mode
Normal: This is the work mode, after the slot card can to open the door.
Card Issuing: This is the issuing mode, after the slot card can to add ID
cards.
Card Revoking: This is the revoking mode, after the slot card can to delete
ID cards.