Page 59 of 66 0455-0323 Rev A
Enable or disable trigger by URI.
User can send commands from remote device or server to a compatible
device, if the command is correct, then device will trigger corresponding
output port.
Input trigger message for trigger by URI mode.
Input reset message for trigger by URI mode.
Enable or disable trigger by SMS.
User can send ALERT command to a compatible
is correct, then device will trigger corresponding output port.
Input trigger message for trigger by SMS mode.
Input reset message for trigger by SMS mode.
Select the input port, when the input port meets the trigger condition, the
output port will be triggered (The Port level time change, By < Output
Duration > control)
Select call state to trigger the output port, options are:
Talking: When the device’s talking status changes, trigger the output
port.
Ringing: When the device’s ringing status changes, trigger the output
port.
Calling: When the device’s calling status changes, trigger the output
port.
Enable or disable trigger by dsskey. If any of the dsskey is selected,
when the dsskey application performs, the output port will be triggered.
Trigger the output port after hanging up
Hang up trigger delay, default 5 seconds
Motion detection settings
Enable or disable motion detection
Set the trigger delay time, the default is 3 seconds, the range:
0~3600 seconds
Support ringtone selection
Send SMS
Enable or disable the input port to send messages to the server
When set to dsskey1 or dsskey2, trigger dsskey to make a call, the
default is none
Enable tamper detection. If the device is violently dismantled, the tamper
is triggered and will always play the set alarm ringtone
When detected someone tampering the device, the alarm signal will be
sent to the corresponding server
When the device receives the command of reset from server, the device
will stop alarm
Reset the play of stop ringtone
To Next Page
Loading...
