ESI A64v - Page 58

Page 58 of 66 0455-0323 Rev A
Security Settings
Parameters
Description
Basic Settings
Ringtone Duration
Set the ringtone duration, default value is 2 seconds.
Input & Tamper Server
Address
Set remote server address. The device will send message to the server
when the alarm is triggered. The message format is：
Alarm_Info:Description=AC64v;SIP User=;Mac=0c:38:3e:3a:06:65;IP=;
port=Input .
Message
Fill in the information to the upload server
Input settings
Input
Enable or disable Input
Triggered by
When choosing the low level trigger (closed trigger), detect the input
port (low level) closed trigger.
When choosing the high level trigger (disconnect trigger), detect the
input port (high level) disconnected trigger.
Input Duration
Set the Input change duration time, the default is 5 seconds.
Triggered Action
Send SMS: Set the alert message send to server if selected.
Event: The device will perform corresponding Dss Key configurations if
any key is selected, by default the value is none.
Triggered Ringtone: Select triggered ring tone.
Triggered Ringtone
Ringtone selection
Output Settings
Enable Logs
Enable or disable LOG
Triggered by DTMF Ring
tone
Select the DTMF trigger ring tone.
Triggered by URI
Ringtone
Select the URI trigger ring tone.
Triggered By SMS
Ringtone
Select the SMS trigger ring tone.
Triggered By Dsskey
Ringtone
Select the Dsskey trigger ring tone.
Output Response
Enable or disable Output Response
Standard Status
When choosing the low level trigger (NO: normally open), when meet the
trigger condition, trigger the NO port disconnected.
When choosing the high level trigger (NC: normally close), when meet
the trigger condition, trigger the NC port close.
Output Duration
Set the output change duration time, the default is 5 seconds.
Input trigger
When the input port meets the trigger condition, the output port will
trigger (the port level time changes, controlled by <output duration>).
Trigger by DTMF
Enable or disable trigger by DTMF. The device will check the received
DTMF sent by remote device, if it matches the DTMF trigger code, the
device will trigger corresponding output port.
DTMF Trigger Code
Input the DTMF trigger code, default value is 1234.
DTMF Reset Code
Input the DTMF reset code, default value is 4321.
Reset By
Reset the output port mode by duration or state.
By duration: Reset the output port status when output duration occurs.
By state: Reset the output port status when device’s call state changes.