150 Ion Operations Manual
{Show Reference Labels} is a global setting that will affect all displays. For some displays such as live
and blind, {Show Reference Labels}can be enabled at the individual tab level by accessing the tab's
configuration menu. This will override the setting in Setup.
In-Cell Editing
When disabled, this setting prevents changes to be made to the cells in the Live/Blind and Playback
Status Displays. {In-Cell Editing} is enabled by default.
Note: Options in the CIA are not affected by this setting.
DirSel.Dbl Clk
When enabled, double clicking a direct select button will act as [Recall From] [Record Target] to place
the entire contents of that preset, palette, or step-based effect on stage. The default for this setting
is “Disabled”.
Trackball Settings
This screen allows you to select various trackball options.
Swap Pan/Tilt
This touchbutton swaps the directions for Pan and Tilt on a trackball. The default for Pan and Tilt is X
and Y, respectively. When this button is enabled, Pan and Tilt will be Y and X.
Reverse Pan
This touchbutton reverses the direction of Pan.
Reverse Tilt
This touchbutton reverses the direction of Tilt.
Reset
This button resets all three trackball settings back to their default.
Brightness Settings
This screen on Ion allows you to adjust the brightness and contrast settings for the Ion display, sub-
wing display, the light level for desk lamps, and the direct select brightness.
Desk Lamp
Desk lamps, such as Littlites, can be dimmed from within the software application. The {Desk Lamp}
slider has a range of 0% (dimmest) to 100% (brightest). The default setting is 0%. The console will
set the desk lamp to this setting on startup of the application.
The desk lamps can also be controlled by holding down [Displays] and rolling the level wheel.
To Next Page
Loading...
