ETC ION - Page 232

230 Ion Operations Manual
Dwell Time
This is the time the fader look will hold before starting the downfade. This can be set to a specified
time, or to “Hold” or “Manual”. “H old” time maintains the fader values until the bump is pressed a
second time. “Manual” time applies the fader values only as long as the bump is held. The default is
“Manual”.
DownTime
This is the time for the fader to fade from its target position to its home position. The default time is
0.
Stomp Mode
Stomp happens when all the content owned by a fader is now being controlled by other targets. The
fader is being removed from the background , and once that happens, it would not be eligible to
fade back. You can assign behavior that will happen when a fader is stomped.
Off When Stomped - puts the content into an off state, the same behavior encountered when
pressing [Off] + [Load].
Unload When Stomped - unloads the fader.
Nothing When Stomped - no action happens to the fader.
Release When Stomped -This function behaves the same as Off When Stomped.
Unmark at 0%
When this option is on, marked content controlled by the fader will automatically be released when
the fader reaches 0%. When the bump button is next pressed, the fader will fire. If this option is off,
you would need to first press the bump button to reset the fader before pressing the bump again to
fire it.
Note: This option is for faders that are set to Intensity Master.
Exclusions
Those exclusions include:
Exclude From Record - output is not recorded into any other record target.
Exclude From Grandmaster - content cannot be mastered by a grandmaster.
Exclude From Inhibitive Sub - content cannot be mastered by an inhibitive submaster
Exclude From Solo - content will ignore solo. See Fader and Button Configuration (on
page267) for more information on solo.
Channel and Parameter Filters
Channel and Parameter Filters can be used to allow only specified data to be played back. These are
playback filters, and do not impact how data is recorded.
Tap or click on {Chan Filter} to assign channels or groups. Tap or click on {Param Filter} to open a list
of available parameters that you can filter.
When a filter has been applied, an indicator will display in the fader ribbon. C will display for channel
filter, and F is for parameter filter.