The clock setup menus allow you to set the unit’s sample rate and digital audio mode. Available
settings include:
Clock Source
Digital Audio Mode
Clock Status
Word Clock Termination Status
To use the H9000 at the end of a word clock chain, enable Word Clock Termination.
To use the H9000 in the middle of a word clock chain, disable Word Clock Termination and use a
BNC T piece.
To adjust the clock source:
Use the cursor keys to highlight the clock source setting
Press the Enter button or adjust the wheel to reveal up a popup menu with available choices for
that setting.
Use the cursor up/down buttons or wheel to select your desired choice
Press the enter key again to select that choice.
2.1.4.1. Clock Source
The clock source is the digital audio clock to which your H9000 synchronizes. You can select an
internal clock at various sample rates; alternatively, you can synchronize your H9000’s system clock
to an external clock signal derived from the following sources:
Internal 44.1 kHz
Internal 48 kHz
Internal 88.2 kHz
Internal 96 kHz
AES Any (any AES signal feeding the 8-channel AES connector)
•
•
•
•
•
•
•
•
•
•
•
•
•
2. Setup
Copyright © 2021, Eventide Inc.
To Next Page
Loading...
