7.2.PlaylistSpecificFunctionsand
Interfaces
7.2.1.Overview
When a playlist is loaded, the Playlist screen appears on the Remote Panel touchscreen. It displays the
content of the active playlist. See section "The Playlist Screen on the Remote Panel Touchscreen" on
page 135.
On the LSM-VIAViewer, the Playlist pane can be opened on the right-side of the screen. It displays the
active playlist. See section "The Playlist Pane on the Viewer" on page 139.
Both interfaces are synchronized.
The functions available in Playlist mode from the Remote Panel console then appear on the key display
of the operational blocks. See section "Playlist Mode Commands on the Remote Panel Console" on page
145.
7.2.2.PlaylistModes
Playlist Playout Mode versus Playlist Edit Mode
The playlist can be used according to two different modes:
• The "Playlist Edit Mode" on page 132 is used to modify the playlist.
• The "Playlist Playout Mode" on page 133 is used to roll the playlist on-air.
Playlist Edit Mode
How to Enter the Playlist Edit Mode
The Edit mode is enabled in one of the following ways:
• when you load the playlist by pressing once. See section "Loading a Playlist" on page
218.
The playlist is then paused on the TCINof the first playlist element.
• when you start browsing the playlist, would the playlist be loaded in Playout or Edit mode.
The playlist is then paused at the current TCof the playlist element that was being played out.
132| January 2022 | Issue 1.4.G
To Next Page
Loading...
Need help?
General