Behavior with a Remote Playlist
A remote playlist cannot be edited. So, the following actions cannot be performed on a remote playlist.
In bold, these are the actions described in the "Transition and Audio Operations" on page 185 section.
It is not possible to
• add clips to a remote playlist
• merge a playlist into the active remote playlist
• move a playlist element
• sort the elements by TCIN
• delete elements from a remote playlist
• add a Cut in a playlist element
• edit the speed of an element
• edit the transition effect of an element
• edit the effect duration of an element
• set an audio split
• set an audio swap or mute an audio track
• set/update/delete the AUX clip of the playlist
A remote playlist cannot be deleted.
A remote playlist can only be loaded, browsed and played out.
7.5.1.TransitionEffects
Introduction
You can apply effects on the audio and video transitions of an element in a playlist. For each transition,
you can define the effect type and duration. Available transition effects are explained in section
"Overview of the Transition Effects" on page 187.
By default, a mix transition effect (audio and video) is applied to each new element inserted into the
playlist. However, you can change the type of transition effect, or its duration, as explained in section
"Adding Transition Effects in a Playlist" on page 189.
With the current version of LSM-VIA, the type of the audio transitions is tied to the type of the video
transitions.
With the Conditional mode, transition effects are played only if the Mix-on-one channel
parameter is set.
186| January 2022 | Issue 1.4.G
To Next Page
Loading...
Need help?
General