7.6.Loading,BrowsingandPlayingPlaylists
This chapter describes the different ways to load a playlist, and the loading behavior depending on the
channel control mode. It also explains the various ways to browse a playlist and gives explanation about
the playlist rollout.
It is possible to load, browse and play a remote playlist.
7.6.1.LoadingaPlaylist
Playlist Conditional and Always Modes - Loading Behavior
The Conditional or Always mode determines the way a playlist will be loaded.
By default, the Always mode is active. The default setting can be changed from the LSM-VIA
configuration tool
The table below summarizes the playlist loading behavior.
Channel Control Mode Always Conditional
PGM+PRV PGM+PRV PGM+PRV
Multi PGM, with control of a single PGM PGM+PRV 1 PGM (controlled PGM)
Multi PGM, with control of more than one PGM PGM+PRV PGM+PRV
The loading behavior in PGM+PRVis as follows:
• the first playlist element is loaded on the PGM.
• the second playlist element is loaded on the PRV.
In Multi-PGM mode, when a single PGM is controlled and the playlist is NOT loaded in PGM+PRV:
• Only the first playlist element is loaded on the controlled channel.
The Conditional mode is intended to be used, for example, in one of the following cases:
• to load and control several playlists simultaneously
• to load the same playlist on two different channels, for example to play it on a channel and edit it on
another channel.
218| January 2022 | Issue 1.4.G
To Next Page
Loading...