› Switching on the machine.
› Cleaning the rollers.
› Adjust the machine.
› Defining the pre-settings (setup)
› Routine operations: Test run with petroleum jelly.
During operation, the rollers of the machine are driven.
This causes a danger of being pulled in.
› When working at the machine, pay attention to your hands and
fingers.
› For cleaning, set up the cleaning plate and change into cleaning
mode.
› Only use the machine with the provided safety devices.
› In routine operation, always work with the limiting jaws inserted to
the correct working width (according to the selected safety
device).
› In routine operation, supply or remove product only with the
spatula.
› Only use one-part spatulas or riveted spatulas with long handle.
› ALWAYS keep the spatula as far away as possible from gap 1
(nip gap roller 1 and roller 2).
Danger of scalding or burns at the media and at hot machine parts
when handling hot temperature control media.
› Before handling temperature control media, let them cool down.
› Wear safety gloves and protective clothing.
To Next Page
Loading...