Transport
52
The TILT sensor indicates whether the machine has
been tilted during transport.
8.2. INTERMEDIATE STORAGE
› Leave the machine in the packaging until it is installed
› Protect the machine from outer influence (humidity, etc.)
› Avoid temperature fluctuation, danger of corrosion due to condensation
› Relative humidity max. 65 %
› Antifreeze during transport and storage: Drain cooling lines completely.
8.3. UNCRATING
Cordless screwdriver, crosstip-bit,
Additional person to help.
Danger of transport damage!
Upon delivery, the packaging is equipped with a position sensor (TILT
sensor). Immediately at delivery by the carrier, check if the sensor is intact.
If not, notify the carrier immediately and let the driver confirm this.
The transfer of risk from manufacturer to final customer takes place with
leaving the factory premises of EXAKT / Germany.
To Next Page
Loading...