Setup
74
27891EN-900-02 / Edition 02/2017
1. Before assembly, clean all parts.
2. Mount scraper bar (e) with 3 screws (c) to the scraper socket (a).
3. Loosen the clamping screws (b).
4. Insert scraper knife (f) (with plastic knife guard). Make sure that the sharp
edge points forwards and the sharpened side of the knife edge points up, i.e.
is visible. (see arrow in detail A).
5. Push scraper knife to the stop (g) of the scraper bar (on the right, viewed
from the top).
6. Mount adaptor (d). Make sure that the groove of the adaptor sits in the stop
of the scraper bar.
7. Tighten the clamping screws (b) ! hand-tight ! as required.
8. Before operation, remove the plastic knife guard and put on the knife guard
for the scraper socket.
To Next Page
Loading...