S2000 Elite - User's Guide
035-00707 Revision 1
10
• Should this S2000 Elite unit be used in a manner not specified by Excelitas
Canada, the protection provided by the equipment may be impaired.
• The lamp module’s operational life can be significantly shortened if it is
handled incorrectly. Do not touch the bulb’s glass envelope or the inside
surface of the reflector. Skin oils can cause the lamp module to fail
prematurely.
• Any electronic equipment connected to the S2000 Elite must be IEC950
certified.
• Clean exterior of the unit with a water dampened cloth and simple detergent
only.
• UV emitted from this product. Avoid eye and skin exposure to unshielded
product.
• Ensure the light guide is properly inserted into the S2000 Elite before turning
on POWER to the unit. This will minimize the risk of exposure to the UV
radiation.
• Before opening the unit and handling the lamp module, allow the lamp module
to cool down completely (approximately 20 min).
• Possibly hazardous optical radiation emitted from this product. Do not stare
into operating lamp.
• Eye damage may result from directly viewing the light produced by the
lamp used in this product. Always use the UV protective eyewear supplied
with the unit and always turn the lamp off before removing lamp housing
cover.
• Never look into the light emitting end of the light guide. The light could
severely damage the cornea and retina of the eye if the light is observed
directly. Eye shielding must be used at all times as well as clothing to
protect exposed skin.
• UV protective eyewear must meet the following recommended optical
specifications: Spectral range 320-500 nm
To Next Page
Loading...
Need help?
General