• Disconnecting the main supply source is only possible by unplugging the
POWER cord.
• To reduce the risk of fire or shock, always replace the fuses with the same
type and rating. Always detach the POWER supply cord before attempting to
replace fuses!
• This unit contains HIGH VOLTAGE components. It is recommended that
ONLY QUALIFIED TECHNICAL PERSONNEL perform any testing or repairs.
• Only use detachable MAINS supply cord with adequate RATING supplied by
Excelitas Canada Inc. with the S2000 Elite unit. Using inadequate/lower
RATING MAINS supply cord in a manner not specified by Excelitas Canada,
the protection provided by the equipment may be impaired.
• Monitoring the unit during manual operation: The Level of UV energy
supplied by the S2000 Elite is sufficient to ignite flammable substances.
During manual operation, the unit must be attended at all times by a qualified
operator. The unit must not be left unattended while turned on. If an operator
leaves the work area of the unit, the POWER switch must be turned off.
• Monitoring the unit during automated operation: The Level of UV energy
supplied by the S2000 Elite is sufficient to ignite flammable substances.
Therefore, when the unit is operated unattended in an automated
environment, the user must provide an alarm function to indicate a malfunction
in the associated equipment used.
• Exposure to Mercury represents a health hazard to humans: When
unpacking or installing the lamp, always wear protective clothing and a face
mask. Operate lamp only in the S2000 Elite lamp housing. This prevents direct
viewing of the arc and in the case of lamp bursting, contains the lamp
particles. In the rare instance in which a lamp bursting occurs, and the
mercury content is released, the following safety precautions are
recommended: all personnel should be immediately evacuated from the area
to prevent inhalation of the mercury vapour. The area should be well ventilated
for a minimum of 30 minutes. Before cleaning up, ensure an approved
mercury respirator mask and non-porous gloves such as latex or rubber are
used. After the lamp housing elements have cooled, the mercury residue
should be collected with the use of a special absorbing agent available from
laboratory equipment suppliers.
• The method in which lamps are disposed of must comply with local rules &
regulations for disposal of hazardous materials. Lamps may be returned to
Excelitas Canada, providing they are returned in its original packaging.
Excelitas Canada will dispose of them in the appropriate manner.
To Next Page
Loading...
Need help?
General