S2000 Elite - User's Guide
035-00707 Revision 1
108
13.3. Software Update via USB
The S2000 Elite's System Software (.EEC) can be upgraded using a Windows PC and a USB
cable.
Materials Required
1. S2000 Elite System with reliable power source
2. Windows PC with the provided update package downloaded. The package contains:
a. Excelitas Updater Application (ExcelitasUpdate.exe)
b. The USB Software Update file: ldgi.eec
3. Supplied USB Type-B to Type-A Cable
The USB update method is only for the System Software. To upgrade the Web
Software, refer to update via Touch Screen or update via WEB UI
Upgrading the System Software using USB is estimated to take 5 minutes.
Operating System required: Windows 8 minimum. Windows 10 recommended.
Performing the System Software Upgrade
Do not disconnect the system power supply once the System Software update has
started. Otherwise, you will be required to restart your upgrade.
If updating both the System and the Web Software, the System Software needs to be
updated first.
The system lamp must be OFF or READY before starting the upgrade. If the lamp is
COOLING or WARMING UP, you must wait for that process to complete.
1. Power on your S2000 Elite unit
2. Connect the USB cable from the S2000 Elite with your Windows PC
3. Launch the Excelitas Updater Application and hit the Start button
4. Follow the on screen instructions for completing the upgrade
5. Perform a power cycle on the unit (flip the ON/OFF switch on the rear panel)
To Next Page
Loading...
Need help?
General