Excelitas Technologies OmniCure S2000 Elite

To Next Page

To Previous Page

S2000 Elite - User's Guide

035-00707 Revision 1

101

Performing the System Software Upgrade

Do not disconnect the system power supply once the System Software update has

started. Otherwise, you will be required to Software Update via USB method.

If updating both the System and the Web Software, the System Software needs to be

updated first.

The system lamp must be OFF or READY before starting the upgrade. If the lamp is

COOLING or WARMING UP, you must wait for that process to complete.

1. Power on your S2000 Elite unit and insert the SD card into the system

2. Using the touchscreen, navigate to Settings → Load Save and select the “SD Card” and

“Firmware Update” toggles on the bottom of the screen. The files loaded on the SD card

should now appear

3. Using the UP or DOWN navigation buttons or the touchscreen, select the .EES file you

wish to load and press the “LOAD” button on the touchscreen, or the keypad ENTER

button

4. The system will prompt a warning to confirm if you wish to continue with the update,

select the Check Mark to continue. If your lamp is on, the system will request to turn the

lamp off before proceeding

5. The system screen will update with a warning prompt that the upgrade is in progress

6. The system screen will turn black and the light guide ring will flash GREEN confirming

the system upgrade is in progress. The system will reboot after the update completes.

If the light guide ring flashes BLUE instead of GREEN during the software upgrade,

the system has detected a corrupt file and is requesting for the files to be loaded

through USB. Refer to Software Update via USB method.

Performing the Web Software Upgrade