S2000 Elite - User's Guide
035-00707 Revision 1
98
4. Place the protective cap onto the light guide input end while cleaning the output end.
5. Wipe output end of light guide with non-abrasive lint-free lens tissue or optical swab
saturated with an IPA cleaning solution with sufficient pressure until the staining has
disappeared.
6. For excessive adhesive build-up on the light-emitting end, lightly scrape the adhesive
build-up with a wooden stick such as tongue depressor/popsicle stick. Take care not to
damage the quartz lens.
7. Re-install the light guide as per the instructions located in the relevant UV spot curing
manual/user guide.
8. For cleaning R2000 optical input port; wipe surfaces with non-abrasive lint-free lens
tissue or optical swab saturated with an IPA cleaning solution until the staining has
disappeared. Care is to be taken to avoid puddling/over-saturation of input port.
To Next Page
Loading...