Safety Information
FTB-1v2 and FTB-1v2 Pro 25
Electrical Safety Information
Measurement category Not rated for measurement categories II, III, or IV
Input power
e
 all models, except high-power dual carrier:
 unit: 24 V; 3.75 A
 AC/DC power adapter:
100 - 240 V; 50/60 Hz; 2.5 A
 high-power dual carrier:
 unit: 24 V; 8.33 A
 AC/DC power adapter:
100 - 240 V; 50/60 Hz; 3.5 - 2.5 A
a. When the unit is used at an altitude of 5000 m, the maximum operating temperature is 32 °C (89.6 °F)
b. Operating time is dependent upon power consumption and temperature. If the unit is used at maximum
power and maximum temperature, it will power off automatically any time after 10 minutes for safety
reasons.
c. Measured in 0 °C to 31 °C (32 °F to 87.8 °F) range, decreasing linearly to 50 % at 40 °C (104 °F).
d. Equipment must be normally protected against exposure to direct sunlight, precipitation and full wind
pressure.
e. Not exceeding ± 10 % of the nominal voltage.
CAUTION
 The use of voltages higher than those indicated on the label
affixed to your unit may damage the unit.
 The operation and storage temperatures, as well as the altitude
and relative humidity values of some modules may differ from
those specified for your platform. In this case, always ensure
that you comply with the most restrictive conditions (either
module or platform).
Equipment Ratings