FTB-1v2 and FTB-1v2 Pro 27
3 Getting Started with Your Unit
Inserting and Removing FTBx Test Modules
CAUTION
 If you are working with FTB modules, see Attaching and
Removing FTB Test Modules on page 33 to avoid damaging your
unit and modules.
If you are not sure about the type of module you are using, see
the section about working with FTBx and FTB modules.
 There is no need to turn off your unit before inserting or
removing FTBx test modules. However, removing FTBx modules
without following the instructions provided in this user
documentation could have unfortunate consequences. Doing so
could result in unexpected behavior of the test applications,
instability of the system, or even cause irreparable damage to
your modules, depending on the operation underway when the
modules are removed.
 To avoid damaging your unit, use it only with modules
approved by EXFO.
To Next Page
Loading...
Need help?
General
