BlackDiamond 8800 Series Switches Hardware Installation Guide
115
Figure 71: Injector/ejector Handles in an Open Position
6 Keep the injector/ejector handles in the open position as you slide the module into the chassis slot.
Do not slide the module into the open chassis slot if the injector/ejector handles are in the latched position.
7 Use both hands to latch the injector/ejector handles, by simultaneously pushing both handles
toward the center of the module, as shown in Figure 72.
Figure 72: Injector/ejector Handles in the Latched Position
Two different styles of ejector/injector handles are on the BlackDiamond 8800 series modules. Pay careful
attention to the instructions in the next step.
To Next Page
Loading...
