Optional Ports for the Summit X460 Series Switches
Summit Family Switches Hardware Installation Guide
169
Optional Ports for the Summit X460 Series Switches
The rear panel of all Summit X460 switches provides slots to install the following:
● XGM3-2sf port option card
● XGM3S-2sf option card
● XGM3S-2xf option card
● Summit X460 series stacking module
● XGM3SB-4sf option card
XGM3-2sf Port Option Card
The XGM3-2sf option card (Figure 130) allows you to add one or two 10-gigabit SFP+ optical ports to
slot A on the rear panel of a Summit X460 series switch. The XGM3-2sf option card supports SFP+
optical modules and the SFP+ direct-attach passive copper cable.
The ports on the XGM3-2sf option card can be configured as alternate stacking ports in a SummitStack
configuration that uses the SummitStack-V feature. For more information about stacking Summit family
switches, see Chapter 5.
Figure 130: XGM3-2sf Option Card
For current information about compatible SFP+ modules and the minimum required software, refer to
the most recent version of the ExtremeXOS Hardware and Software Compatibility Matrix.
For more information about SFP+ modules, refer to the Extreme Networks Pluggable Interfaces Hardware
Installation Guide.
XGM3S-2sf Port Option Card
The XGM3S-2sf option card (Figure 131) allows you to add one or two 10-Gigabit SFP+ optical ports to
slot A on the rear panel of a Summit X460 series switch. These ports support synchronous Ethernet
(Sync-E). The XGM3S-2sf option card supports either SFP+ optical modules or the SFP+ direct-attach
passive copper cable.
SFP+ ports
LEDs
SH_190
To Next Page
Loading...
