Extreme Networks Summit X430 Series - Safety Information; Installing a Summit Family Switch (Models Other than Summit X460, X480, X650, and X670 Series)

Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
232
Safety Information
Read the information in this chapter thoroughly before you attempt to install or remove a
Summit switch.
NOTE
See Appendix A, “Safety Information,” for additional safety information and Appendix B, “Technical
Specifications” for additional information regarding regulatory compliance certifications.
CAUTION
Be sure that proper ESD controls are in use before switch maintenance is performed. This includes but is
not limited to wrist straps that are grounded to the switch chassis and earth grounds.
WARNING!
Be sure to connect the chassis ground wire before you connect any DC power cables.
Be sure to disconnect the ground wire after you disconnect all DC power cables.
Installing a Summit Family Switch (Models Other than
Summit X460, X480, X650, and X670 Series)
This section describes how to install the following Summit family switches:
● Summit X150 series
● Summit X250e series
● Summit X350 series
● Summit X440 series
● Summit X450 series
● Summit X450a series
● Summit X450e series
For instructions to install the Summit X460 series switches, see “Installing a Summit X460 Series Switch”
on page 241.
For instructions to install the Summit X480 series switches, see “Installing a Summit X480 Series Switch”
on page 258.
For instructions to install the Summit X650 series switches, see “Installing a Summit X650 Series Switch”
on page 275.
For instructions to install the Summit X670 series switches, see “Installing a Summit X670 Series Switch”
on page 291.