Removing a Summit X650 Series Switch
Summit Family Switches Hardware Installation Guide
393
Removing a Summit X650 Series Switch
This section provides procedures for removing a Summit X650 series switch from a two-post or
four-post equipment rack.
Before you remove a Summit X650 series switch from the rack, remove all installed power supplies, as
described in one of the following sections:
● “Removing a Summit X650 AC Power Supply” on page 393
● “Removing a Summit X650 DC Power Supply” on page 394
Removing a Summit X650 AC Power Supply
To remove a Summit X650 AC power supply:
1 Disconnect the power cord from the wall outlet and from the power input connector on the power
supply.
2 Push the latching tab to the left as you pull the handle to disengage the power supply from its
internal connectors (Figure 334).
3 Carefully slide the power supply out of the switch and set it aside.
Figure 334: Removing a Summit X650 AC Power Supply
SH_096
To Next Page
Loading...
