Extreme Networks Summit X430 Series - Preparing the Cables; Installing the Power Supply

Installing Summit X650 Power Supplies
Summit Family Switches Hardware Installation Guide
285
Preparing the Cables
A ring terminal and two spade terminals are provided with the power supply. You need a crimping tool
to attach the terminals to the power and ground cables.
To prepare the cables:
1 On each wire, strip 0.25 inch of insulation from one end.
2 Insert the stripped wire end all the way into the barrel of the terminal (Figure 232) and crimp the
terminal securely to the wire.
Figure 232: Attaching Terminals to Cables
Installing the Power Supply
CAUTION
The handle on the Summit X650 DC power supply is not designed to be used to lift or carry the Summit
X650 series switch.
To install an 850 W DC power supply in a Summit X650 series switch:
1 If necessary, remove a blank panel from the back of the Summit X650 series switch (Figure 233).
Figure 233: Removing a Blank Panel
SH_109
SH_110
Power connection wire
Ground wire
SH_106