Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
276
Selecting Rear Mounting Brackets
To allow installation of the switch in cabinets of different depths, the Summit X650 series switch has
two sets of rear mounting brackets. Use the bracket that best suits the cabinet depth or rack depth
where the switch will be installed:
● Shorter brackets—cabinets or racks 25 inches to 31 inches (63.5 cm to 76.7 cm) deep
● Longer brackets—cabinets or racks 25 inches to 36 inches (63.5 cm to 91.4 cm) deep
For a two-post rack installation, the shorter brackets are recommended.
Installing the Switch in a Two-Post Rack
To install the switch in a two-post rack:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to an appropriate
ground point on the rack.
2 Using rack-mounting screws suitable for your rack, attach a rear mounting bracket to the back of
each rack post (Figure 221).
Do not tighten the screws all the way. You should be able to move the brackets against the rack post.
Figure 221: Attaching a Rear Mounting Bracket—Two-Post Rack Installation
3 From the back of the equipment rack, slide the switch into place over the mounting brackets (see
Figure 222). Make sure the brackets slide between the support pegs on both sides of the switch.
SH_097
To Next Page
Loading...
