Extreme Networks Summit X430 Series - Removing a Front-Mounted Switch from a Two-Post Rack

Removing a Summit X480 Series Switch
Summit Family Switches Hardware Installation Guide
391
5 Remove the rack-mounting screws and detach the rear mounting brackets from the rack post
(Figure 331).
Figure 331: Removing the Rear Mounting Brackets
Removing a Front-Mounted Switch from a Two-Post Rack
Removing a front-mounted Summit X480 switch from a rack requires two people to maneuver the
switch and disconnect the mounting hardware.
To remove a front-mounted switch:
1 Verify that all power supplies have been removed from the switch.
2 Support the switch while you remove the rack-mounting screws holding the front mounting brackets
in place against the rack post (Figure 332).
3 Slide the switch out of the rack.
Figure 332: Removing a Front-Mounted Switch from a Two-Post Rack
SH_125
SH_130