Summit Family Switches Hardware Installation Guide
301
CHAPTER
7
Installing Summit External
Power Supplies
This chapter describes how to install external power supplies with the Summit family switches. The
chapter includes the following sections:
● Safety on page 301
● Installing an EPS-160 External Power Module (with EPS-T) on page 303
● Installing an EPS-LD External Power Supply on page 306
● Installing an EPS-500 External Power Supply Unit on page 309
● Installing an EPS-600LS External Power Module on page 312
● Installing an EPS-150DC External Power Module (with EPS-T2) on page 317
● Installing an EPS-C2 Chassis on page 322
Read the information in this chapter thoroughly before you start to install or remove an external
power supply.
Safety
Only trained service personnel should perform service to Extreme Networks switches and their
components. Trained service personnel have read all related installation manuals, have the technical
training and experience necessary to be aware of the hazards to which they are exposed in performing a
task, and are aware of measures to minimize the danger to themselves or other persons.
NOTE
See Appendix B, “Technical Specifications” for additional information regarding regulatory
compliance certifications.
CAUTION
Before installing or removing any components of the system, or before carrying out any maintenance
procedures, read the safety information provided in Appendix A of this guide. Not following these precautions can
result in equipment damage or shock.
To Next Page
Loading...
