Extreme Networks Summit X430 Series - Installing an EPS-150 DC External Power Module (with EPS-T2)

Installing an EPS-150DC External Power Module (with EPS-T2)
Summit Family Switches Hardware Installation Guide
317
Installing an EPS-150DC External Power Module
(with EPS-T2)
The EPS-150DC power supply is a modular power supply for use in the EPS-T2 External Power System
Tray. The EPS-T2 is a rack-mountable chassis or tray that holds one or two EPS-150DC power supplies.
Each EPS-150DC provides one-to-one redundancy to an attached Extreme Networks switch. You must
install the EPS-150DC power supply in the EPS-T2 tray.
NOTE
For centralized DC power connection, this product is intended to be installed in restricted access locations
(dedicated equipment rooms, equipment closets, or the like) in accordance with Articles 110-16, 110-17, and 110-18
of the National Electric Code, ANSI/NFPA 70.
CAUTION
Do not use the rack-mount brackets to suspend the EPS-T2 from under a table or desk, or to attach the
EPS-T2 to a wall.
Rack-mounting the EPS-T2
To install the EPS-T2:
1 Place the EPS-T2 upright on a secure surface, with the front facing you.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets:
a Place a mounting bracket over the mounting holes on one side of the EPS-T2 (Figure 259).
b Insert the provided screws and fully tighten with a screwdriver.
Figure 259: Attaching the Mounting Bracket
c Repeat steps a and b for the other side of the EPS-T2.
4 Slide the EPS-T2 into a 19-inch rack and secure it using appropriate rack-mounting screws.
ES4K026