Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
270
4 Verify that the power supply is right side up (see Figure 216).
5 Carefully slide the power supply all the way into the power supply bay (see Figure 216). Push the
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
Figure 216: Installing a DC Power Supply
6 To install a second power supply, repeat steps 3 through 5.
Connecting the Ground Wire
WARNING!
Be sure to connect the chassis ground wire before you connect any power cables.
Be sure to disconnect the ground wire after you disconnect all power cables.
You need a #1 Phillips screwdriver to secure the ground wire to the power supply.
To connect the ground wire:
1 Verify that the DC circuit is de-energized.
2 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
3 Pull the cover off the terminal block (Figure 217).
SH_158
To Next Page
Loading...
