Extreme Networks Summit X430 Series - Connecting the Ground Wire

Chapter 10: Replacing DC Power Supplies in Summit Family Switches
Summit Family Switches Hardware Installation Guide
356
Connecting the Ground Wire
To connect the ground wire to the Summit 300 W DC power supply:
1 Verify that the DC circuit is de-energized.
2 Identify the grounding point on the front panel of the power supply (see Figure 313).
3 Insert an M3.5 screw (provided) through the ring terminal on the ground wire and into the
grounding point on the power supply.
4 Tighten the screw to 12.6 inch-pounds.
5 Connect the other end of the wire to a known reliable earth ground point at your site.
Figure 299: Connecting the Ground Wire
(Model 10934A)
Figure 300: Connecting the Ground Wire
(Model 10933)
SH_209
1
2
1 = Grounding point
2 = Ground wire
1
2
1 = Grounding point
2 = Ground wire