Extreme Networks Summit X430 Series - MID-Mounting a Switch in a Two-Post Rack

Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
292
● AC power cord for each installed AC power supply
An AC power cord is not included with the Summit X460 series switch. You must obtain a power
supply cord that meets the requirements listed under
“Power Cord Requirements for AC-Powered
Switches and AC Power Supplies” on page 500
.
● #14 AWG copper cable for grounding the switch
The recommended insulation color is green or green with yellow stripe
● Stripping tool
● Crimping tool for attaching the ring terminal to the ground wire
● ESD-preventive wrist strap for installing optional ports at the back of the switch
Mid-Mounting a Switch in a Two-Post Rack
To mid-mount a Summit X670 series switch in a two-post rack:
1 On one side of the switch, set a mounting bracket against the switch housing, with the flange toward
the back of the switch (see Figure 238).
2 Use six of the provided screws to secure the bracket to the switch housing.
3 Repeat these steps to attach the other bracket to the other side of the switch.
Figure 238: Attaching a Rack-mounting Bracket
SH_255