Chapter 5: Building a SummitStack Configuration
Summit Family Switches Hardware Installation Guide
214
NOTE
SummitStack-V320 stacking can be mixed with V160, V80, and 10G alternate port stacking. For example,
a Summit X460 with SummitStack-V80 could be added to the sample stack in Figure 152. However, you must
restrict the speed of the ports on the VIM3-40G4X and VIM4-40G4X that connect to any ports on nodes operating
at slower speeds. To reduce the speed of ports on the VIM3-40G4X or VIM4-40G4X, use the configure
stacking-support stack-ports selection command. For more information about configuring stacking
ports, see the ExtremeXOS Concepts Guide.
Table 74: Recommended Order for Stacking Connections (three-switch stack)
Connect this slot and port . . . . . . To this slot and port
Slot 1 Stack Port 2
(physical ports 2
and 4)
Slot 2 Stack Port 1
(physical ports
1and 3)
Slot 2 Stack Port 2
(physical ports 2
and 4)
Slot 3 Stack Port 1
(physical ports 1
and 3)
Slot 3 Stack Port 2
(physical ports 2
and 4)
Slot 1 Stack Port 1
(physical ports 1
and 3)
To Next Page
Loading...
