Installing a Summit Family Switch (Models Other than Summit X460, X480, X650, and X670 Series)
Summit Family Switches Hardware Installation Guide
237
WARNING!
Be sure to connect the chassis ground wire before you connect any power cables.
To ground the switch:
1 At one end of the wire, strip the insulation to expose 1/2 inch (12 mm) of bare wire.
2 Identify the grounding lug on the back of the switch. The grounding lug is next to the edge of the
back panel, identified by the international symbol for earth ground. Depending on the switch model,
the grounding lug may be on either side (see Figure 175).
Figure 175: Location of the Grounding Lug
3 Insert the stripped wire into the grounding lug (see Figure 176 and Figure 177).
Figure 176: Attaching the Ground Wire to a Summit x450a Series Switch
SH_060
Summit X450a series
DC-powered switch
Summit X250e series
DC-powered switch
SH_061
To Next Page
Loading...
