Extreme Networks Summit X430 Series - Page 248

Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
248
Figure 187: Installing a 750 W AC Power Supply
NOTE
If power supplies are not installed in both power supply bays, be sure to install a cover over the
unoccupied bay. Unoccupied bays must always be covered to maintain proper system ventilation and EMI
levels.
4 Connect the AC power cord as follows:
a If necessary, slide the plastic cord retainer farther away from the back of the switch (Figure 188).
Figure 188: Moving the Power Cord Retainer
b Connect the AC power cord to the input connector (Figure 189).
SH_205
SH_227