Chapter 6: Installing Summit Family Switches
Summit Family Switches Hardware Installation Guide
278
5 At the front of the switch, place a front mounting bracket against each side of the switch, in front of
the ventilation openings in the side of the switch (Figure 224)
Make sure there is space between the bracket and the ventilation openings.
Figure 224: Positioning the Front Mounting Brackets—Two-Post Rack
6 Using the provided screws, attach each front bracket to the switch (Figure 224).
7 Slide the switch back in the rack until the front mounting brackets are against the front of the rack
post (Figure 225).
Make sure that the ventilation holes in the side of the switch are within the open channel of the rack
post.
Figure 225: Securing the Front Mounting Brackets to the Rack
8 Using mounting screws suitable for your equipment rack, secure the mounting brackets to the front
of the rack post.
After the switch is secured to the rack, install and connect power supplies as described in “Installing an
850 W AC Power Supply in a Summit X650 Series Switch” on page 282 or “Installing an 850 W DC
Power Supply in a Summit X650 Series Switch” on page 284.
SH_099
SH_100
To Next Page
Loading...
