Installing an EPS-600LS External Power Module
Summit Family Switches Hardware Installation Guide
313
Figure 254: Attaching the Mounting Bracket
c Repeat steps a and b for the other side of the EPS-C.
4 Slide the EPS-C into a 19-inch rack and secure it using appropriate rack-mount screws.
5 Connect the keyed end of the redundant power cord to the EPS-C (see Figure 255). Verify that the
side of the connector marked TOP is facing up.
The key is a plastic tab on the cable connector housing that fits into the EPS-C to ensure correct
alignment of the connector.
6 Connect the other end of the redundant power cord to the Summit X450e-48p or X250e-48p switch
(see Figure 255). Be sure that the side of the connector marked TOP is facing up.
Figure 255: Installing the Redundant Power Cord
EP
S-C
EPS-C_01
Rack Mount Bracket
EPS-C
EPS-C_03A
Redundant Power Output
! See Manual
Connect First
To Next Page
Loading...
