B680H 37 732719 - Rev.E
Translation of the original instructions
ENGLISH
Expert Function Setting
t
Work time (time-out)
Maximum work time of the automation before the motor stops, if the open or closed position
is not reached. The value can be regulated from O to 59 sec. in 1 second steps. The
display subsequently changes to minutes and tens of seconds (separated by a point) and the
time is adjusted in 10 second steps, up to a maximum value of 4.1 minutes.
30
dr
Red light brightness (OUT 5)
Changing this value increases or decreases the output voltage for OUT 5, changing the
brightness of the rope light.
04
dG
Green light brightness (OUT 6)
Changing this value increases or decreases the output voltage for OUT 5, changing the
brightness of the rope light.
04
St
AUTOMATION SYSTEM STATUS:
Exit from programming, data storage and automation status display.
To Next Page
Loading...
