Fagor CNC 8055i FL EN - Page 675

Installation manual
CNC 8055
CNC 8055i
H.
SOFT: V02.2X
·675·
Summary of PLC inputs and outputs
Axis logic outputs.
Spindle logic outputs.
DM08 M5540 The coolant output has been activated (M08).
DM09 M5555 The coolant output has been canceled (M09).
DM19 M5554 A block with spindle stop has been executed (M19).
DM30 M5553 The program concluded after executing the auxiliary M30 function.
DM41 M5552 First spindle speed gear (range) selected (M41).
DM42 M5551 Second spindle speed gear (range) selected (M42).
DM43 M5550 Third spindle speed gear (range) selected (M43).
DM44 M5549 Fourth spindle speed gear (range) selected (M44).
DM45 M5548 Auxiliary spindle or live tool selected (M45).
TANGACT M5558 G45 active
SYNCPOSI M5559 Spindles synchronized in position.
SYNSPEED M5560 Spindles synchronized in speed.
SYNCHRON M5561 G77S function selected (spindle synchronization).
SERPLCAC M5562 Requested change of parameter set and gear ratio in progress.
RETRACT M5567 It indicates that the drilling or mill type threading operation or the lathe type threading
withdrawal has stopped.
TMINEM M5569 It indicates tha the CNC has detected an error during tool change.
Axis 1
Axis 2
Axis 3
Axis 4
Axis 5
Axis 6
Axis 7
ENABLE* M5600
M5650
M5700
M5750
M5800
M5850
M5900 Enables axis movement.
DIR* M5601
M5651
M5701
M5751
M5801
M5851
M5901 Indicate axis moving direction.
REFPOIN* M5602
M5652
M5702
M5752
M5802
M5852
M5902 Home search done.
DRSTAF* M5603
M5653
M5703
M5753
M5803
M5853
M5903 With Sercos. They indicate servo drive status.
DRSTAS* M5604
M5654
M5704
M5754
M5804
M5854
M5904 With Sercos. They indicate servo drive status.
ANT* M5606
M5656
M5706
M5756
M5806
M5856
M5906 If distance < MINMOVE (P54), ANT*=1
INPOS* M5607
M5657
M5707
M5757
M5807
M5857
M5907 Axis in position.
Main Second
ENABLES M5950 ENABLES2 M5975 Enables spindle movement.
DIRS M5951 DIRS2 M5976 Spindle turning direction
REFPOINS M5952 REFPOIS2 M5977 The spindle has been already referenced (homed).
DRSTAFS M5953 DRSTAFS2 M5978 With Sercos. They indicate servo drive status.
DRSTASS M5954 DRSTASS2 M5979 With Sercos. They indicate servo drive status.
CAXIS M5955 CAXIS2 M5980 "C" axis active.
REVOK M5956 REVOK2 M5981 Spindle rpm correspond to programmed speed.
INPOSS M5957 INPOSS2 M5982 Spindle in position.