·118·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the axes and spindles.
REPOSITIONING OF THE AXES IN TOOL INSPECTION.
REPOSFEED
Maximum repositioning feedrate.
Parameter valid for linear and rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 200000.0000 mm/min or degrees/min / from 0 to 7873.992 inch/min.
Default value: 0.
Associated variable: (V.)[ch].MPA.REPOSFEED.xn
Repositioning feedrate after a tool inspection. If not defined, the CNC assumes as
repositioning feedrate the one defined for the jog mode (JOGFEED).
The value of parameter REPOSFEED must always be lower than G00FEED,
MAXMANFEED and JOGRAPFEED.
CONFIGURATION OF THE INDEPENDENT AXIS.
POSFEED
Positioning feedrate.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 36000000.0000 mm/min or degrees/min / from 0 to 1417322.83465 inch/min.
Default value: 1000.
Associated variable: (V.)[ch].MPA.POSFEED.xn
Positioning feedrate of the independent axis.
CONFIGURE THE MAXIMUM SAFETY LIMIT FOR THE
FEEDRATE AND FOR THE SPEED.
FLIMIT
Maximum safety limit for axis feedrate.
Parameter valid for linear and rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 500000.0000 mm/min / from 0 to 19685.03937 inch/min / from 0 to
72000000.0000 degrees/min.
Default value: 0 (there is no limitation).
Associated variable: (V.)[ch].MPA.FLIMIT.xn
This parameter sets the maximum safety limit for axis feedrate to be applied, for example,
when performing maintenance on the machine, operations with disabled safety (open doors),
etc. The set value is activated via PLC (marks FLIMITAC or FLIMITACCHC1) and the CNC
applies it on the block being executed. When deactivating the limits, the CNC restores the
programmed feedrate.
If the parameter is set with a "0" value, the feedrate is not limited. The feedrate safety limit
is applied to the movements in automatic (G0, G1, etc.) and in jog mode (jog, handwheels,
etc.). This parameter affects neither the threading operations nor the independent axis
movements, which are executed at the programmed feedrate.
When there is a maximum feedrate set by PLC (variable (V.)PLC.G00FEED), the CNC
applies the most restrictive feedrate.
SLIMIT
Maximum safety limit for spindle speed.
Parameter valid for spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 200000.0000 rpm.
Default value: 0 (there is no limitation).
Associated variable: (V.)[ch].MPA.SLIMIT.sn
This parameter sets the maximum safety limit for spindle speed to be applied, for example,
when performing maintenance on the machine, operations with disabled safety (open doors),
To Next Page
Loading...
