Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·119·
Machine parameters for the axes and spindles.
etc. The set value is activated via PLC (marks SLIMITAC or SLIMITACSPDL) and the CNC
applies it on the block being executed. When deactivating the limits, the CNC restores the
programmed speed.
If the parameter is set with a "0" value, the speed is not limited. The safety limit is also applied
to the spindles controlled by PLC (PLCCNTL mark), except when the spindle is digital and
controlled in position.
It is also possible to set the maximum machining turning speed by program (function G192)
or by PLC (variable (V.)PLC.SL.sn). When a maximum machining speed has been set, the
CNC applies the most restrictive speed limit; either the one set for machining or the safety
one.
JOG MODE.
MANUAL
Manual operating mode parameters
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
This parameter shows the parameter table to define the movements in jog mode. On
spindles, these parameters will only be applied when the spindle is interpolated with axes
during rigid tapping or when the spindle works as C axis.
Safety speed limit. Machining speed limit. Active speed limit.
0 100 100
50 0 50
50 100 50
150 100 100
JOGFEED Feedrate in continuous jog mode.
JOGRAPFEED Rapid feedrate in continuous jog mode.
MAXMANFEED Maximum feedrate in continuous jog mode.
MAXMANACC Maximum acceleration in continuous JOG mode.
INCJOGDIST Distance to travel in incremental jog.
INCJOGFEED Feedrate in incremental jog.
MPGRESOL Handwheel resolution.
MPGFILTER Filter time for the handwheel.
MANPOSSW Maximum positive travel with G201.
MANNEGSW Maximum negative travel with G201.
MANFEEDP Maximum % of jog feedrate in G201.
IPOFEEDP Maximum % of execution feedrate in G201.
MANACCP Maximum % of jog acceleration in G201.
IPOACCP Maximum % of execution acceleration in G201.
To Next Page
Loading...
