Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·63·
General machine parameters.
DATA
Table to define the compensation values.
This parameter shows the list of compensation points and values. The CNC only lets access
this table when parameters are MOVAXIS, COMPAXIS and NPCROSS set.
The DATA table must indicate the amount of error to be compensated in specific positions
of the moving axis. The number of points is set by parameter NPCROSS. Parameters
POSITION, POSERROR and NEGERROR must be set for each point. Parameter
NEGERROR only if the table has been defined with bidirectional compensation (BIDIR =
YES).
POSITION
Position of the master axis.
Possible values: Within ±99999.9999 mm or degrees / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)MPG.POSITION[tbl][pt]
Parameter included in the CROSSCOMP // DATA table.
This parameter sets the position of the master axis in each point of the compensation. The
points of the table must be ordered by their position on the axis and the table must begin
by the most negative point (or least positive) to be compensated. For axis positioning outside
this area, the CNC will apply the compensation that was defined for the nearest end.
POSERROR
Amount of error to compensate when moving in the positive
direction.
Possible values: Within ±99999.9999 mm or degrees / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)MPG.POSERROR[tbl][pt]
Parameter included in the CROSSCOMP // DATA table.
This parameter indicates the amount of error on the compensated axis when the master axis
moves in the positive direction. If the table has not been defined with bi-directional
compensation, this amount of error will also be applied on movements in the negative
direction.
The machine reference point must have "0" error.
NEGERROR
Amount of error to compensate when moving in the negative
direction.
Possible values: Within ±99999.9999 mm or degrees / within ±3937.00787 inch.
Default value: 0.
Associated variable: (V.)MPG.NEGERROR[tbl][pt]
Parameter included in the CROSSCOMP // DATA table.
This parameter indicates the amount of error on the compensated axis when the master axis
moves in the negative direction. This compensation is only available if the table has been
defined with bidirectional compensation.
The machine reference point must have "0" error.
CROSSCOMP
DATA
POSITION Position of the master axis.
POSERROR Amount of error to compensate when moving in the positive
direction.
NEGERROR Amount of error to compensate when moving in the negative
direction.
To Next Page
Loading...
