Fagor CNC 8060 - Page 65

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·65·
General machine parameters.
REFTIME
Estimated home searching time.
Possible values: From 0 to 1000000 ms.
Default value: 0. ms.
Associated variable: (V.)MPG.REFTIME
See general machine parameter TTIME.
HTIME
Estimated time for an H function.
Possible values: From 0 to 1000000 ms.
Default value: 0. ms.
Associated variable: (V.)MPG.HTIME
See general machine parameter TTIME.
DTIME
Estimated time for a D function.
Possible values: From 0 to 1000000 ms.
Default value: 0. ms.
Associated variable: (V.)MPG.DTIME
See general machine parameter TTIME.
TTIME
Estimated time for a T function.
Possible values: From 0 to 1000000 ms.
Default value: 0. ms.
Associated variable: (V.)MPG.TTIME
In Editing - Simulation mode, there is an option that allows calculating the time required to
execute a part with the machining conditions established in the program. To fine tune that
calculation, one may define these parameters that indicate the estimated time for processing
particular functions.
The values are generic, for any H, D, T function or for homing one or several axes at a time.
Spindle machine parameter SPDLTIME indicates the estimated time for executing an S
function and the machine parameter of the M function table –M– MTIME indicates the time
estimated to execute an M function.
NUMBERING OF THE DIGITAL INPUTS AND OUTPUTS.
NDIMOD
Total number of digital input modules.
Possible values: From 0 to 64.
Default value: 0 (no numbering is defined).
Associated variable: (V.)MPG.NDIMOD
This parameter indicates the number of these modules connected to the same CAN bus.
In remote modules with CANopen protocol each double module of digital inputs and outputs
counts as two.
After defining this value, it is possible to set the numbering of the digital inputs of each module.
If this parameter is not set, the CNC numbers the digital inputs sequentially according to the
order of the modules in the bus.
DIMODADDR
Table of digital input modules.
This parameter shows the list of digital input modules connected to the same bus CAN. When
inserting a new module, the CNC will assign the numbering of the table to the first modules
and the next valid base index after the highest one assigned until then to the last module.