Fagor CNC 8060 - Page 863

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·863·
Variables related to the programmed functions.
Values of the variable.
This variable returns one of the following values.
(V.)G.ANGIDST[nb]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Status of the angular transformation [nb] of the machine parameters.
Syntax.
·nb· Number of the angular transformation in the order defined in the machine parameters.
Values of the variable.
This variable returns one of the following values.
TANGENTIAL CONTROL STATUS.
(V.)[ch].G.TGCTRLST
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Status of tangential control in the channel.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
Value. Meaning.
0Off.
1On.
2 Frozen (suspended).
V.G.ANGIDST[1] Angular transformation ·1·.
Value. Meaning.
0Off.
1On.
2 Frozen (suspended).
V.[2].G.TGCTRLST Channel ·2·.
Value. Meaning.
0Off.
1On.
2 Frozen (suspended).