Possible actions:
Show Scan in Map - This option is only available for finished scans. Tap the right arrow to view the
map page. The view centers on the selected scan, and it is marked in the map.
Register - Again This option is available for scans that either succeeded or failed in registering.
A dialog pops up when you tap the right arrow. Tap Confirm to re-register the scan. The scan is being
re-registered, and the registration status is displayed as Unknown until the process is completed.
Remove Scan from Map - This option is available for scans shown in the map that were successfully
registered.
A dialog pops up when you tap the right arrow. Use Confirm to remove the scan from map. Although
the scan is removed from the map, it is not deleted. The scan status is Registration Failed after it is
removed from the map.
Delete Scan - This option is only available for scans that are not In Progress.
Tap the right arrow to view the Delete scan dialog. Use Confirm to delete the scan.
CAUTION: The scan is deleted from the cluster or project.
On-Site Compensation
On-site compensation (OCS) is a process that tests and improves the angular accuracy of the scanner by
measuring and correcting small inconsistencies in how the scanner measures the environment. These
inconsistencies are then compensated for in the scanner's software.
Choose the Compensation Site
Before you begin the OSC process, ensure that the scan site has the following facilities:
l Indoor room without movements (persons, objects or i.e. fan at ceiling etc.) and natural objects well
distributed within the room.
l No windows or other reflective planes should be in evidence. This may cause incorrect measurements.
l Walls, floor and ceiling should not have plain walls but structure.
l Lighting conditions are less important because on-site compensation is done with the laser, so video
images are not used.
l Download the FARO Stream app from Apple or Google store.
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 7: Special Scanning Modes
FARO Focus Premium (March 2022) Page114of157
To Next Page
Loading...
