Faro Focus Premium - Inverting the Scanner

l For scans close to the ground, slide all leg segments into each other before setting the leg angle to
flat. The rubber feet have a recess that helps to achieve full-surface contact, even with a flat leg angle.
To do this, turn the feet individually by hand.
l Ensure that the twist-lock sleeves for leg length adjustment, the central wing nut of the tripod
shoulder, and the tripod head are always tightly screwed together.
l To achieve a better grip on hard surfaces, slightly tension the tripod legs before starting a scan.
Tension the legs by holding two of the three tripod legs as close to the ground as possible with your
hands, pulling them slightly apart from each other and away from the third leg, then pressing them
into the ground.
l Under windy conditions, use sandbags to stabilize each foot of the tripod. You can also stretch a rope
or shock cord between the tripod’s center hook and a weight, switchable magnetic base, or existing
anchor point.
Inverting the scanner
The scanner can be mounted upside-down. In an inverted position, the scanner's documented IP rating is
no longer valid, so take care to prevent water from dripping on the scanner.
l Ensure that no person is underneath the scanner during setup and operation.
l The setup you create to hold the scanner should be able to support at least 5 kg (11 lbs.).
l Use a tripod only if it is suitable for inverted installations (the ACCSS8032 tripod is not suitable).
l The setup must be as rigid as possible and must prevent vibrations and oscillations.
l Ensure that the scanner can not loosen or fall from your setup. Make sure your mounting is locked
safely and can not open under weight.
l Ensure that the scanner can rotate without touching anything.
l Keep the cooling fan openings uncovered and at least 18 cm (7 in) from any surface.
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 5: Getting Started
FARO Focus Premium (March 2022) Page31of157