Faro Focus Premium - Page 129

4. Small dropping bottle and medium wash bottles, available from optical or chemical supply stores
such as:
n https://www.thorlabs.de/thorproduct.cfm?partnumber=B2939
5. Stainless steel forceps, available from optical or chemical supply stores such as:
n https://www.thorlabs.de/thorproduct.cfm?partnumber=FCP
(Forceps, solid stainless steel)
n https://www.thorlabs.de/thorproduct.cfm?partnumber=FCPA
(Angled Forceps, solid stainless steel)
6. Powder-free lab gloves (PVC or silicone), available from optical or chemical supply stores.
7. For strongly contaminated optics, Mild neutral soap, available from optical or chemical supply
stores.
Cleaning Slightly Contaminated Optics
WARNING: Hand injuries due to spinning mirror
If the scanner is accidentally switched on, the mirrors may start to turn. Before starting
any cleaning activity:
- shut-down the laser scanner module and remove the battery pack.
- if using an external power supply, remove the power line.
This will prevent the mirror from turning during the cleaning.
Dry Pre-Cleaning (Non-Contact Cleaning)
Start removal of dust or liquid droplet contamination on mirror or sensor cover by using compressed dry
air or special duster sprays (dry cleaning gas).
NOTICE: Do not shake the Duster Spray bottle.
While using the duster spray, ensure that you do not shake the bottle or turn it upside down.
FARO
®
Focus Premium Laser Scanner User Manual
Chapter 8: Maintenance
FARO Focus Premium (March 2022) Page122of157